Просмотр полной версии : iphone 4s error 3 need some advice
Hello
I am working on iPhone 4s i bought a iCloud lock iphone 4s and i did remove the NAND,imei and the baseband from iCloud lock phone which was working fine and transplanted non iCloud lock and imei and baseband to this iCloud lock board. The problem i am having is this phone is now giving error 3. i went through the updater log and it shows that baseband fails in second stage of firmware update. the first stage goes through fine. Also i might have made mistake which i am not sure, i have to baseband ic and i am thinking maybe i might have mixed them up. could that be the reason that i am getting error 3?
I did try with both baseband ic one baseband ic is giving error 3 and the other baseband ic is giving Error 1? if baseband does not match with imei and nand what error it would throw? I also checked the baseband pmu and all voltage are good coming from pmu,.....
Please advice need help
Thanks for reading my post
asg-gealt
06.02.2015, 10:24
Поработаю переводчиком:
Привет
Работаю с iPhone 4s, который я купил с блокировкой iCloud. Я заменил нанд, имеи и baseband. Телефон сейчас выдает ошибку 3. Я просмотрел лог апдейта - на второй стадии baseband выдает ошибку. Первая стадия прошивки проходит нормально. Возможно я перепутал микросхемы бэйсбэнд, их две, не уверен. Может из-за этого выдавать ошибку 3?
Я попробовал обе микросхемы baseband - с одной была ошибка 3, с другой 1. Если бэйсбэнд не соответствует имеи и нанду какая ошибка должна быть? Я также проверить КП baseband - все напряжения в норме.
Помогите, пожалуйста, советом.
here is the log from itune
_AMAuthInstallBundleCreateServerRequestDictionary: entry "rfta" not part of manifest, skipping
[16:18:09.0312] amai: _AMAuthInstallBundleCreateServerRequestDictionary: entry "ftsp" not part of manifest, skipping
[16:18:09.0312] amai: _AMAuthInstallBundleCreateServerRequestDictionary: entry "rfts" not part of manifest, skipping
[16:18:09.0312] amai: _AMAuthInstallBundleCreateServerRequestDictionary: entry "BasebandFirmware" has been previously personalized; skipping it
[16:18:09.0312] amai: _AMAuthInstallBundleCreateServerRequestDictionary: not personalizing "BatteryLow1"
[16:18:09.0312] amai: _AMAuthInstallBundleCreateServerRequestDictionary: not personalizing "BatteryLow0"
[16:18:09.0312] amai: _AMAuthInstallBundleCreateServerRequestDictionary: entry "LLB" has been previously personalized; skipping it
[16:18:09.0328] amai: _AMAuthInstallBundleCreateServerRequestDictionary: not personalizing "iBoot"
[16:18:09.0328] amai: _AMAuthInstallBundleCreateServerRequestDictionary: not personalizing "DeviceTree"
[16:18:09.0328] amai: _AMAuthInstallBundleCreateServerRequestDictionary: not personalizing "BatteryCharging1"
[16:18:09.0328] amai: _AMAuthInstallBundleCreateServerRequestDictionary: not personalizing "AppleLogo"
[16:18:09.0328] amai: _AMAuthInstallBundleCreateServerRequestDictionary: not personalizing "BatteryPlugin"
[16:18:09.0328] amai: _AMAuthInstallBundleCreateServerRequestDictionary: not personalizing "BatteryFull"
[16:18:09.0328] amai: _AMAuthInstallBundleCreateServerRequestDictionary: not personalizing "BatteryCharging0"
[16:18:09.0328] amai: _AMAuthInstallBundleCreateServerRequestDictionary: not personalizing "RecoveryMode"
[16:18:09.0343] amai: _AMAuthInstallBundleCreateServerRequestDictionary: nothing to be done
[16:19:32.0015] <Restore Device 0E4FC8F8>: operation 19 progress 1
[16:19:32.0281] <Restore Device 0E4FC8F8>: operation 19 progress 1
[16:19:32.0531] <Restore Device 0E4FC8F8>: operation 19 progress 1
[16:19:32.0796] <Restore Device 0E4FC8F8>: operation 19 progress 1
[16:20:54.0250] amai: AMAuthInstallBasebandHandleUpdaterStatus: commandAccepted: NO
[16:20:54.0265] device returned CFError with code -1
[16:20:54.0265] dumping CFError returned by restored:
[16:20:54.0265] CFError domainXXXXXXXXXXXXXXXXXXXin code:-1 description:failed to update device firmware
[16:20:54.0265] CFError domainXXXXXXXXXXXXXXXXXXXin code:-1 description:ramrod firmware update failed
[16:20:54.0265] CFError domainXXXXXXXXXrorDomain code:1004 description:update_baseband: failed to perform next stage
[16:20:54.0265] CFError domainXXXXXXXXXr code:3 description:Failed programming firmware.
[16:20:54.0281] Sending acknowledgement that final status was received
[16:20:56.0343] Restore completed, status:3
[16:20:56.0343] Failure Description:
[16:20:56.0343] Depth:0 Error:AMRestorePerformRestoreModeRestoreWithError failed with error: -1
[16:20:56.0343] Depth:1 Error:The operation couldn’t be completed. (AMRestoreErrorDomain error -1 - Failed to handle message type StatusMsg)
[16:20:56.0343] Depth:2 Error:The operation couldn’t be completed. (AMRestoreErrorDomain error -1 - failed to update device firmware)
[16:20:56.0343] Depth:3 Error:The operation couldn’t be completed. (AMRestoreErrorDomain error -1 - ramrod firmware update failed)
[16:20:56.0343] Depth:4 Error:The operation couldn’t be completed. (RamrodErrorDomain error 1004 - update_baseband: failed to perform next stage)
[16:20:56.0343] Depth:5 Error:The operation couldn’t be completed. (BBUpdater error 3 - Failed programming firmware.)
cooperlonely
08.02.2015, 05:24
Check eeprom and reball modem again..
And if you use another modem, you get error 27..
Also NAND is not may be any baseband problem.
Whic one is eeprom on 4a??
cooperlonely
08.02.2015, 05:31
What??? Baseband eeprom, because NAND is not eeprom ;-)
Which chip is eeprom on 4s
cooperlonely
08.02.2015, 05:36
LoL
Wait, i'll go to schematic
U12_rf. It is eeprom of modem, whithout it - error 16, with another - err 27.
I know I did not use eeprom from other board I only changed bb nand and imei chip
Cooper also I am getting error 9 on 5s please help me with that too
cooperlonely
08.02.2015, 05:40
Try use the search with tags: iphone 5s error 9 and 5s ошибка 9.
Use the google translator for translating answers.
cooperlonely
08.02.2015, 05:42
I know I did not use eeprom from other board I only changed bb nand and imei chip
"Imei chip" - eeprom baseband - u12_rf.
May be you are destruct it...
cooperlonely
08.02.2015, 05:53
Yeah, why you don't know it ? Schematic ?
cooperlonely
08.02.2015, 05:56
How about search there? iphone 4s error 3 site:forum.gsmhosting.com
I did search for error 9 and 3 I am almost done and give up on these phones I am tired
I did not find any salution that's why
cooperlonely
08.02.2015, 06:03
Solutions for loosers, imho.
Use your brain and skill, all about that error you find and read, think about it.. Many many times. Good luck.
If I mixed up baseband with different phone it will give error 3 right
OM Tesla
08.02.2015, 06:11
Better f*** off to gsmhosting.com and not forget to use schematic :laugh:
May be its wrong baseband chip. If I mixed up baseband the nand should not work also right and not just eeprom
Wites is it you?? Why you say f*** to me wites I know you or is it wites friend?? Cyberdocllc?!
cooperlonely
08.02.2015, 06:15
It right only for different eeprom, NAND is no matter for firmware update process, actually after update your device is not activating. Read more about UDID and how it generate for request to activate on apple server.
Hmm thank you cooper you best my friend
cooperlonely
08.02.2015, 06:21
Yes, he is Philip
Why he use bad words for me [emoji17]
cooperlonely
08.02.2015, 06:32
That's russian humor, joke :************ off to gsmhosting - not bad words for you, it a comic recommendation :-)
Oh ok sorry I did not understand
cooperlonely
08.02.2015, 06:34
So... Good Luck and good night, i'll go sleep
[QUOTE=d42k11;2460642]Why he use bad words for me [emoji17][/QUOTE
У Русских ребят очень "широкая душа". Просто так мы никогда никого обижать не будем. Ты тебе помогаем, но не обижаем.
"Сooperlonely" - правильно написал - 27 ошибка если не совпадает BB $ EEPROM.
Если ошибка 1 или 3 - это BB CPU - или катай, или Тебе не повезло...