sabian
19.09.2014, 14:01
При нажатии кнопки вкл. просто вибро. Ресуррект делал, в рекавери не входит.
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.37, JTAG Manager Version: 1.56
Selected Resurrector: [GSmart G1342 V1.0.5277.42322]
Connecting to the dead ************...OK
Detected dead ************ ID: 0x106040E1 - CORRECT!
Set I/O Voltage reads as 2.59V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at 1 MHz]
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK
Detected an Initialized FLASH1 Chip, ID: 0x00EC/0x66B3 (1024MB)
Selected Resurrection Data for the NAND Chip with Page size = 4KB
Flashing the dead ************...OK
Resurrection complete!
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.37, JTAG Manager Version: 1.56
Selected Resurrector: [GSmart G1342 V1.0.5277.42322]
Connecting to the dead ************...OK
Detected dead ************ ID: 0x106040E1 - CORRECT!
Set I/O Voltage reads as 2.59V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at 1 MHz]
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK
Detected an Initialized FLASH1 Chip, ID: 0x00EC/0x66B3 (1024MB)
Selected Resurrection Data for the NAND Chip with Page size = 4KB
Flashing the dead ************...OK
Resurrection complete!